Basic Parameters

1. Size: 1250mm(L)×1150mm(D)×1850mm(H);

2. Power supply: 220V 50HZ

3. Air supply: 0.5MPa

4. No corrosive gas, liquid, explosive gas

5. Color: supplier standard color sample (international warm gray 1C).

Technical parameters

1. Applicable specifications: length L50-150, width W 30-90mm, thickness H 0-20mm;

The tab length Q≤25mm

2. Equipment speed: 1.3-1.6s/pcs;

3. Alignment accuracy between pole piece and diaphragm: center deviation±0.3mm;

4. Incoming requirements: the coating of the pole piece must be uniform, the thickness error should be less than 0.005mm, and there should be no wrinkling and bonding; The length and width size error is less than ±0.2 mm, and the wavy edge is less than 1mm (does not affect the positioning of the pole piece); The tab is flat, without bending, bending, etc.; The diaphragm should be rewound evenly, with a width error of less than 0.1mm and a tower error of less than 0.2mm.

5. The active unwinding of the diaphragm is controlled by appropriate tension during the lamination process to ensure that the extension and deformation of the diaphragm is small;

6. Diaphragm correction to ensure the uniformity of diaphragm unwinding, and the alignment accuracy ±0.2mm;

7. Defective identification: identify missing pieces.

8. The utilization rate is 95% (only the fault caused by the machine), and the pass rate is 98% (the defect is only caused by the machine)